Let us help you get those kneelers looking like new again! We offer two styles sure to work perfectly with the kneelers found in your place of worship. Kneeler Pads for Original Atwood-Hamlin Kneelers: These kneeler pads measure 4 3/4" wide and feature a 5/8" plywood base, 1 1/4" high-density foam, as well as your choice of high quality Vinyl, Sherpa/Shire or Interweave Fabric patterns. Style A Kneeler Pads: Our Style A Kneeler Pads are made for kneelers with a stringer (wood support strip) down the middle and is typically mounted by screws down the center. The covering of the pad reaches underneath to within 1/2" from the center on both sides. The stringer will then cover the staples found down the middle. Style A uses more fabric than other pads, and less cuts per roll. Please note, this type requires a thicker plywood base, usually 3/4" minimum. The strength of the kneeler is based on the thickness of the pad. When measuring for Style A Kneeler Pads, measure width of pad and length of pad to the nearest 1/8". If possible, please provide pictures of your kneelers. See diagram above. Style B Kneeler Pads: Our Style B Kneeler Pads are made for kneelers with a full support stringer and are typically mounted by multiple screws down both sides and covers the entire bottom of the kneeler pad. See diagram above. Measuring for Kneeler Pads: When measuring for Style A or Style B Kneeler Pads, measure the width of pad and length of pad to the nearest 1/8". If possible, please provide pictures of your kneelers. All kneeler pads can be made using 3/4", 3/8", or 5/8" plywood. Due to size variations, please contact Customer Service at 866-213-3780 or email us at [email protected] to request a custom quote.
|